Below shows the commands for creating a file of ekill commands for a selected set of elements.
Same idea can be used for ealive. Note that the db does not keep track of ealive/ekill so this needs modified to be cummulative.
! select elements to be killed then use these commands to make
! a file of ekill cmds to be read in the restart
!
*get,ecount,elem,,count
*dim,elst,array,ecount
*vget,elst(1),elem, ,elist
*cfopen,ekill,inp
*vwrite,elst(1)
('ekill,',f8.0)
*cfclose
-------------------------
modified version to test basic logic:
! select elements to be killed then use these commands to make
! a file of ekill cmds to be read in the restart
!
ecount=5
!*get,ecount,elem,,count
*dim,elst,array,ecount
!*vget,elst(1),elem, ,elist
elst(1)=2,4,6,8,15
*cfopen,ekill,inp
*vwrite,elst(1)
('ekill,',f8.0)
*cfclose
output: ekill.inp file
ekill, 2.
ekill, 4.
ekill, 6.
ekill, 8.
ekill, 15.
Can also make CM of Killed elements & then use it to kill them again after RESTART.
----------------------------- ekill 1st step, ealive 2nd step
1.Add a command object under the contact region he wants to kill containing the following commands:
cont=cid
targ=tid
2.Set up Analysis settings for 2 loadsteps.
3.Add two command objects to the Static Structural Environment branch. One for EKILL and one for EALIVE and use the command object details window to assign each of these to be executed right before LS 1 and LS 2 respectively.
EKILL command object should have the following:
esel,s,type,,cont
esel,a,type,,targ
ekill,all
allsel
EALIVE command object should have the following
esel,s,type,,cont
esel,a,type,,targ
ealive,all
allsel
------------------ execute an EKILL on elements that exceed a certain stress level and run a restart
use *VWRITE to write out the list of elements to be killed to an external txt file and then read this file in before executing the restart.
